Medtronic Revel Uživatelská příručka stáhnout pdf (Strana 142)

Opening and viewing the graphs

The following table describes how to use the graphs.

If you want to: Do the following:

Open the graphs From the HOME screen, press ESC. The last graph you viewed (3-, 6-,

12- or 24-hour) shows the details for your most recent sensor glucose

(SG) measurement.

View information in a graph If there is no SG measurement at the time you select, the reason for

the missing measurement will be shown on the right side of the graph

(for example, LOST SENSOR).

• When you open the graphs, the cursor (flashing vertical line) is always on

the right edge of the graph and the graph shows the most recent SG

measurement.

•

Press

to move the cursor left to see an earlier SG measurement.

•

Press

to move the cursor right to return to more recent SG

measurements.

View different graphs

•

With the cursor at the far right edge of a graph, you can press

to open

the next graph.

• If the cursor is anywhere to the left of the far right edge, press ESC to

move it to the right, then press

to open the next graph.

The graphs

All graphs show High and Low Glucose Limits lines, a real-time SG measurement line, a data section, and

the cursor (flashing vertical line).

When you open any graph, the cursor flashes on the right edge of the graph. There are three marks on the

cursor at 100, 200, and 300 mg/dL (or 5, 10, and 15 if mmol/L is selected). The data section shows the

most recent SG measurement or the reason why no measurement shows, and the time in the data section

matches the time at the top of the screen.

Using your sensor 121

Chapter 8

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 264 265

Žádné komentáře

Medtronic Revel Uživatelská příručka Strana 142