Medtronic Revel Uživatelská příručka stáhnout pdf (Strana 128)

Setting the High Repeat

After you receive and clear a High Glucose, Rise Rate of Change, or High Predictive alert, the alert will

repeat until the condition that has caused the alert is resolved. The High Repeat feature allows you to set

how frequently you want the alert to repeat after you clear it the first time. For example, if your blood

glucose levels usually take one to two hours to fall after a correction bolus, you may want to set the High

Repeat to one or two hours to avoid unnecessary alerts.

Example

You set your High Repeat to 15 minutes. You receive an alert at 1:00 PM and immediately clear it.

However, the condition that caused the alert still exists, so you will receive a second alert at 1:15 PM,

15 minutes after you cleared the first alert. If you immediately clear the alert again, then the alert will

repeat at 1:30 PM and continue to repeat every 15 minutes until you resolve the condition that caused the

alert. (This example also applies to the Low Repeat.)

To set up your High Repeat:

1 Make sure the EDIT SETTINGS screen is open.

Main > Sensor > Edit Settings

2 Select Hi Repeat, then press ACT. The SET HI ALERT REPEAT screen flashes the default High Repeat

time of 1 hour (1:00).

3 Select your High Repeat time. The time must be between 5 minutes (0:05) and 3 hours (3:00).

4 Press ACT. The EDIT SETTINGS screen shows the High Repeat value set.

You are now ready to set up your Low Repeat.

Setting the Low Repeat

After you receive and clear a Low Glucose, Fall Rate of Change, or Low Predictive alert, the alert will

repeat until the condition that caused the alert is resolved. The Low Repeat feature allows you to set how

frequently you want the above alerts or alarm to repeat after you clear it the first time. The Low Repeat

feature works similar to the High Repeat one. See Setting the High Repeat section in this chapter for an

example.

1 Make sure the EDIT SETTINGS screen is open.

Main > Sensor > Edit Settings

2 Select Low Repeat, then press ACT. The SET LO ALERT REPEAT screen flashes the default Lo Alert

Repeat time of 20 minutes (0:20).

Sensor features 107

Chapter 7

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 264 265

Žádné komentáře

Medtronic Revel Uživatelská příručka Strana 128